TechHui

Hawaiʻi's Technology Community

I admit defeat, the thing-o-matic printer was a challenge to build but the PC software and drivers are even more of a rat's nest to instal correctly. Has anyone on Oahu been down this road that can help me out? I would think someone with robot experience might be able to figure it all out in 2 minutes. Maui Makers can pipe in too.

Views: 115

Reply to This

Replies to This Discussion

I gave up on the PC got the mac version of the software installed in minutes. I still can't seem to get the printer to work past setting the xyz coordinates. At least I know all the motors are hooked up correctly and that the soldering training at the box jelly came through.

Reply to Discussion

RSS

Sponsors

web design, web development, localization

© 2019   Created by Daniel Leuck.   Powered by

Badges  |  Report an Issue  |  Terms of Service